Using Your Ceiling Fan - Emerson KEANE CF320BS00 Mode D'emploi

7. Installing the Wall Control
7.3
Attach the SW46W Fan Control to the wall outlet box with
two 6-32 x 3/4" screws (provided with control).
Position the faceplate (provided with control) onto the
speed control. Using the two 6-32 x 1/4" screws, screw the
faceplate and speed control to the wall outlet box
(Figure 26).
Restore power at the main fuse box or circuit breaker
panel.
8.1
IMPORTANT
Fan installation must be completed, including the
installation of the fan blades, before testing of the
controls.
Restore electrical power to the outlet box by turning the
electricity on at the main fuse box.
Check the operation of the fan by sliding the bar of the
control through the four positions marked 1 - 4
("0" position is OFF) (Figure 27).
8.2
All fans are shipped from the factory with the reversing
switch positioned to circulate air downward. If airflow is
desired in opposite direction, turn your fan OFF and wait
for the blades to stop turning, then slide the reversing
switch to the opposite position, and turn fan on again
(Figure 28).
The fan blades will turn in the opposite direction and
reverse the airflow.
Reverse Switch Information
Season Rotation Direction
Summer Counter-Clockwise
Winter Clockwise

8. Using Your Ceiling Fan

Switch Position
Right
Left
16
(Continued)
WALL OUTLET BOX
SW46 FAN CONTROL
6-32 x 1/4" SCREWS (2)
Figure 26
4
3
2
1
0
Figure 27
Figure 28
4
3
2
1
0
6-32 x 3/4"
SCREWS (2)
FACEPLATE
REVERSING SWITCH
ETL Model No.: CF320