German
degrees
(°dH)
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
You must adjust the water soft-
ener manually and electronically.
Manual adjustment
Electronic adjustment
1. Press the on/off button to activate
the appliance.
2. Make sure that the appliance is in
setting mode. Refer to 'SETTING
AND STARTING A PROGRAMME'.
3. Press and hold the programme but-
ton until the programme indicator (A)
starts to flash and the programme in-
dicator (B) comes on.
4. Wait until the programme indicator
(B) goes off and the end indicator
starts to flash (the programme indica-
tor (A) continues to flash).
Water hardness
French
mmol/l
degrees
(°fH)
7 - 18
0.7 - 1.8
< 7
< 0.7
Clarke
degrees
5 - 12
< 5
Turn the water hardness dial to the posi-
tion 1 or 2.
5. Press the programme button.
• The end indicator flashes intermit-
tently. The number of flashes
shows the level of the water soften-
er, e.g. 5 flashes + pause + 5 flash-
es = level 5.
6. To adjust the level of the water soft-
ener, press the programme button.
Each time you press the programme
button you go to the next level.
7. Deactivate the appliance to confirm
the setting.
ENGLISH
25
Water softener
adjustment
Manual
Elec-
tronic
1
2
2)
2)
1
1