AEG FAVORIT 35400 VI Mode D'emploi page 31

Alarm code
• The indicator of the set programme
flashes continuously.
• The end indicator flashes 3 times in-
termittently.
WARNING!
Deactivate the appliance before
you do the checks.
Problem
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
The appliance does not drain
the water.
The anti-flood device is on.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
10.1 The washing results and drying results are not satisfactory
Problem
The dishes are not
clean.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse
in the fuse box.
Make sure that the appliance door is closed.
Make sure that the water tap is open.
Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is
not clogged.
Make sure that the inlet hose has no kinks or
bends.
Make sure that the sink spigot is not clog-
ged.
Make sure that the drain hose has no kinks
or bends.
Close the water tap and contact the Service.
Possible cause
The filters are clogged.
The filters are not correctly
assembled and installed.
The spray arms are clog-
ged.
Problem
The anti-flood device is on.
If other alarm codes appear, contact the
Service.
Possible solution
Clean the filters.
Make sure that the filters
are correctly assembled and
installed.
Remove remaining soil with
a thin pointed object.
ENGLISH
31