Dipswitch - Scaime eNod4-Box Ethernet Guide Rapide

RJ45 connector, Ethernet Communication:
 ModBus TCP, Ethernet/IP or Profinet (depending on version) communication:
•
Electrically isolated from eNod4 power supply.
3 points connector, AUX communication:
•
GND (connector pin3) is connected with power supply GND. The common mode voltage admitted is ± 27VDC from
GND power supply.
•
When eNod4 is positioned at the end of the line the 150 Ω integrated resistor can be used (connecting jumper).
7.2 Address selection
Address selection is done with rotary switches. Rotary switches (SW1 and SW2) are accessible under the front panel. New address
is taken into account after reset.
Example: eNod4 address = 3A
7.3 Flow rate selection
Baud rate selection is done with dipswitches (SW3). Dipswitches are accessible under the front panel. Baud rate modification is
taken into account after reset.
= 58d
H

Dipswitch

1 2
ON ON ON
OFF ON ON
ON OFF ON
OFF OFF ON
ON ON OFF
OFF ON OFF
ON OFF OFF
OFF OFF OFF
Quick Start Guide SCAIME:
Baud rate
RS485 et USB
3 4
X 9600
X 19200
X 38400
X 57600
X 115200
X 9600
X 9600
X 9600
28
NUSG-eNod4-ETH-BOX-FE-246776-A.docx
Bit rate
CAN
50 kbit/s
50 kbit/s
50 kbit/s
125 kbit/s
250 kbit/s
500 kbit/s
1 Mbit/s
125 kbit/s