Power Supply; Introduction - Scaime eNod4-Box Ethernet Guide Rapide

2.2 Protection
The PRODUCT, with 220V option, must be linked to a protection device. This one must comply to the standards in force in the
country (NFC 15-100 in France) and must be part of the building in which the PRODUCT has been installed. The circuit breaker
must be 16 Amps and should have a response curve of type C.
The mains plug of the PRODUCT serves as disconnecting device. Consequently, it must be connected near the device and easily
accessible.

2.3 Power supply

The PRODUCT, with 24VDC version, must be powered by a power supply in accordance to EN 60950-1. It must be located close to
the PRODUCT.
2.4 Grounding
To minimize any risk of electric shock, frame and all parts of the equipment must be connected to Earth.
2.5 Installation
The PRODUCT must be fitted on a support by using the mounting brackets at the rear of the box.
2.6 Maintenance
The PRDUCT can be cleaned using a damp slightly cloth.
For your safety, before any technical intervention or cleaning, it is imperative that the equipment is turned off and not plugged in.
It is forbidden to replace components with power cable connected.
2.7 Caution
When installing, moving, or handling this product or peripherals connected to it, refer to the instructions below to connect and
disconnect the various cords.
Connection:
1. Turn off the units.
2. Start by connecting all cords to the units.
3. Connect the interface cables to the connectors.
4. Connect the power cords into outlet.
5. Turn on the units.

3 INTRODUCTION

eNod4 products are a family of high-speed digital transmitters. They integrate various programmable functions and powerful
signal processing capacities. For a description of the features specific to each version see related documents for each model:
- User's instructions: § 'Characteristics and functioning'
- Communication modes description: § 'Software user manual'
Quick Start Guide SCAIME:
WARNING
WARNING
WARNING
DANGER
DANGER
1. Turn off the units.
2. Disconnect the power cords from the outlets.
3. Disconnect the interface cables from the connectors.
4. Disconnect all cabled from the units.
20
NUSG-eNod4-ETH-BOX-FE-246776-A.docx
Disconnection: