Continuity Test - VOLTCRAFT VC-519 Mode D'emploi

g) Continuity Test
Make sure that all circuit parts, circuits and components and other objects of
measurement are disconnected from the voltage and discharged.
- Turn the DMM on and select measuring
function . Press "MODE" button twice to switch
measurement functions. The symbol for continuity test now
appears in the display. Pressing this button again takes you
to the next measuring function, etc.
- Plug the red measuring line into the V measuring jack (9)
and the black measuring line into the COM measuring jack
(8).
- An approximate value of less than 50 Ohm is identified
as continuity; in this case a beep sounds. The measuring
range is up to 200 Ohm.
- If "OL" (overload) appears on the display, you have
exceeded the measuring range or the measuring circuit is
interrupted.
- Remove the measuring lines from the object to be meas-
ured after completion of the measurement and switch off
the DMM.
53