Electronic Timer; Audible Signal - Elba 106 EX 880 Mode D'emploi

ELECTRONIC CLOCK
The programmer is equipped with an
electronic clock with lighted numbers
which indicates hours and minutes.
Upon immediate connection of the oven
or after a blackout, three zeros will flash
on the programmer panel.
To set the hour it is necessary to push
the button and then the
button until you have set the exact hour
(fig. 7.2).
In another way push simul tane ously the
two buttons and at the same
time push the or
Nota: The hour setting delete any pro-
gram.
NORMAL COOKING WITHOUT THE USE
OF THE PROGRAMMER
To manually use the oven, that is,
without the aid of the programmer, it is
necessary to cancel the flashing AUTO
by pushing the button
switched off and the symbol
on - fig. 7.3).
Attention: If the AUTO is steady lighted
(which means a cooking program has
already been inserted), by pushing the
button you have the cancellation
of the program and the switching to
manual.
If the oven is switch on, you must
switch off manually.
Fig. 7.3
(fig. 7.2)
or
button.
(AUTO will be
will go

ELECTRONIC TIMER

The timer program consists only of a
buzzer which may be set for a maximum
period of 23 hours and 59 minutes.
If the AUTO flashing push the
ton.
To set the time, push the
the or until you obtain the desi-
red time in the panel (fig. 7.4).
Having finished the setting, the clock
hour will appear on the panel and the
symbol will be lighted.
The countdown will start immediately
and may be seen at any moment on the
panel by simply pressing the button
At the end of the time, the
will be switched off and an intermittent
buzzer will go off; this can be stopped
by pressing one of any of the buttons.
SETTING THE FREQUENCY OF THE

AUDIBLE SIGNAL

The selection from 3 possibilities of
sound can be made by pressing the
button.
Fig. 7.4
but-
button and
.
symbol
37