Residual Heat Indicator - Elba 106 EX 880 Mode D'emploi

RESIDUAL HEAT INDICATOR

The hob also features 5 warning lights
which are connected to the correspond-
ing plates.
When the temperature of a cooking
plate is above 60 °C, the relevant warn-
ing light will also light up to warn of
heat on the surface of the hob.
This light also stay on after the cooking
plate has been switched off to show
that the hob surface is still hot.
This residual heat will lasts for a long
time after the cooking plate has been
switched off.
During this time you should avoid
touching the hob
cooking area.
Please pay special attention to ensure
that children are not allowed
the hob.
The light will switch off automatically as
soon as the surface temperature of the
cooking plate falls below 60°C.
Caution!
the cooking hob becomes very
hot during operation.
Keep children well out of reach.
surface over the
near
Cooking hints:
– To reduce the cooking time, you can
turn the control knob to the max
when you switch the plate on.
After a short time you can set the
control knob to the position required
for cooking.
– You should only use pots and pans
with flat bases (pans with the test
mark for glass-ceramic hobs are
available from specialist shops).
The diameter of the pan should match
that of the cooking plate (or be slight-
ly bigger) to make the most of the
energy.
– Since the cooking surface will stays
hot for a certain time after the plate
has been switched off, you can
switch it off 5 or 10 minutes before
the end of the cooking.
The residual heat of the hob will com-
plete the cooking.
– To save electricity, use pan lids
whenever possible.
– Never cook the food directly on the
glass ceramic hob, but in special
pans or containers.
Fig. 2.11
19