Thermador DWHD771W Série Manuel D'utilisation page 26

Delay Start
You can delay the start of the cycle in one hour
increments up to 24 hours.
1 hour delay
œ : ‹‚
24 hours delay
:
œ ƒ...
To set Delay start:
Open the door and press the On/Off button
1.
Select a cycle.
Press the Delay button from the wash cycle options
2.
until the displayed time corresponds with your
h
requirements.
Press the Start button
3.
To cancel Delay start:
Open the door and press the Delay button until
1.
is indicated on the digital display
Press the Start button
2.
Wash cycle end
The wash cycle has ended when the display
: .
‹ ‹‹
If the signal tone has been set, the wash cycle end is
also indicated by a buzzer.
Off
:
à– ‹‹
low
:
à– ‹‚
medium
:
à– ‹ƒ
loud
:
à– ‹„
Auto power off
To save energy, the dishwasher is switched off 1 minute
after the cycle ends. You can also change this setting.
Possible settings are:
: The dishwasher does not switch off
˜ : ‹‹
▯
automatically.
: The dishwasher switches off after 1 minute.
˜ : ‹‚
▯
˜ ‹ƒ : The dishwasher switches off after 2 hours.
:
▯
Switching off the appliance
Short time after the end of the wash cycle:
Open the door.
1.
Switch off On/Off button
2.
Turn off water supply.
3.
Remove the utensils when they have cooled down.
4.
26
(
to activate Delay start.
)"
.
H
to save setting.
)"
H
.
(
WARNING
9
RISK OF INJURY
To avoid risk of injury, always use caution when
opening the door during or following a wash cycle
as hot water or steam may escape. Do not fully
open the door until water noises have stopped and
steam has subsided.
To reduce risk of injury, do not allow children to play
.
in or on the dishwasher.
When children become old enough to operate the
appliance, it is the responsibility of the parents/legal
guardians to ensure the children are instructed in
safe practices by qualified persons.
Interrupting the wash cycle
:
œ ‹‹
CAUTION
9
Expansion (overpressure) may cause the appliance
door to open and/or water to escape! If the door
was opened on an appliance which has a hot water
reads
connection or is heated, always leave the door ajar
for several minutes and then close.
Open the door.
1.
Switch off On/Off switch
2.
The LED's go out. The wash cycle is saved.
To continue the wash cycle, switch on the On/Off
3.
switch
(
Close the door.
4.
Note: Your dishwasher is protected against unintentional
operation. If the appliance door remains open for more
than 4 seconds after pressing the Start button, the
operation will be paused. Press the Start button again
and close the appliance door.
Cancel a cycle (Reset)
Open the door and press and hold Start button
1.
for approximately 3 seconds until the display reads
: , then close door again.
‹ ‹‚
Wait about 1 minute while the dishwasher drains.
2.
Open the door and press the On/Off button
3.
Changing the wash cycle
When the Start button
cycle cannot be changed. The only way a wash cycle can
be changed is by terminating the wash cycle (Reset).
Intensive drying
The final rinse uses a higher temperature which improves
the drying result (be careful if you have delicate dishware
or utensils). The running time may increase slightly. You
can switch the function ExtraDry on
.
(
again.
has been pressed, the wash
(
:
š ‹‚
)"
( .
or off : .
š ‹‹