Publicité
Les langues disponibles
Les langues disponibles
It is also very important that you observe the following procedures:
always use the included screws for the output connection (brass).
When other materials are used there is a risk that the connection will
burn.
make sure that the wires between the charger and the battery make
good contact. If this connection is weak, there is a chance that the
connection will burn.
do not tighten the screws more than necessary. If the screws are
tightened too much the screw and screw hole may be damaged.
If the charger has a malfunction because these procedures are not
observed, the warranty will lapse.
Advice
It is advisable to mount a fuse between the + pole of the battery and the
+ bolt of the charger. Always use a fuse that is heavier than the charge
current.
Mounting
The charger can be mounted in different ways with the mounting plate on
the bottem of the charger. Place the charger on a stabil under ground.
L E D I N D I C A T I O N S
The charging process can be followed with the red, yellow and green
LED below 'charge process':
LED red lights on
LED yellow lights on
LED green lights on
LED green 'power on' light on : Charger is on, 230VAC input present
: Boost charging (main charging)
: Equalize charging
: the battery is full (float charging)
English
14
Publicité
