Controlling The Tv Or The Av Receiver With The Supplied Remote - Sony DVP-S500D Mode D'emploi

Playing Discs in Various Modes
To change the password
1 In Step 5, select "CHANGE PASSWORD" using >/., then
press / or ENTER.
The display for changing the password appears.
2 Follow Steps 4 and 5 to enter a new password.
z
If you have forgot your password
Enter 6 digits number "199703" in Step 4 to clear the
current password. To enter a new password, follow the
procedure from Step 4 again.
Notes
• When you play DVDs which do not have the Parental
Control function, playback cannot be limited on this player.
• When you do not set a password, you cannot change the
settings for playback limitation.
• Depending on the DVD, you may be asked to change the
parental control level while playing the disc. In this case,
enter the password, then change the level.
When you stop playing the DVD, the level returns to the
original level.
Standard
Austria
Belgium
Canada
China
Denmark
Finland
France
Germany
Hong Kong
Indonesia
Italy
Japan
Malaysia
Netherlands
Norway
Philippines
Singapore
Spain
Sweden
Switzerland
Taiwan
Thailand
United Kingdom
EN
30
Code number
2046
2057
2079
2092
2115
2165
2174
2109
2219
2238
2254
2276
2363
2376
2379
2424
2501
2149
2499
2086
2543
2528
2184
Controlling the TV or the AV
receiver with the Supplied
Remote Z
If you adjust the remote signal, you can control your
TVs with the supplied remote. Default setting is to
control Sony TVs with the g mark.
When you connect the player to a Sony AV receiver,
you can also set the input of the receiver to this player
with the supplied remote .
TV/DVD
switch
1 2 3
Number
4 5 6
buttons
7 8 9
0
Controlling TVs with the remote
1
Slide TV/DVD switch to TV.
2
Hold down POWER, and enter your TV's
manufacturer's code in the table below using the
number buttons. Then release POWER.
Code numbers of controllable TVs
If more than one code number is listed, try entering
them one at a time until you find the one that works
with your TV.
Notes
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote commander,
the code number automatically resets to 01 (Sony). Reset the
appropriate code number.
POWER