SPOT sanindusa 543637111 Mode D'emploi page 53

9.
If you want to pulse at level 2, wait for the indicator light to blink twice (j) and then pulse enough
times (k).
In the same way, if you don't need to pulse at any other level, just wait for the indicator light to blink three
times (m) and after blinking four times (p) you'll leave the adjustment mode.
The SPOT tab will remain programmed with the desired flow time.
10.
If you need to pulse at level 3, wait for the indicator light to blink three times (m) and then
pulse enough times (n).
Wait for the LED to blink four times to leave the adjustment mode (p) The SPOT tab will remain programmed
with the desired flow time.
11.
Assemble the lid to the tap body (q).
12.
Turn on the water (r).
13.
Verify that the programmed time is the desired time. If not, wait a few minutes and repeat the
procedure.
// FLOW TIME ADJUSTMENT