SPOT sanindusa 543637111 Mode D'emploi page 52

// FLOW TIME ADJUSTMENT
3.
Disconnect the energy source (battery or transformer) (a).
4.
Press the contact area of the lid for 30 seconds (c).
5.
Switch on the energy source (d).
6.
The indicator light (LED) in the lower part of the Piezo lid (e) will blink a few times becoming constant
immediately (f). At that moment, press the contact area (g) to enter into the adjustment mode (programming
mode).
NOTE: if you don't press the indicated area while the LED is constant, the adjustment mode won't activate
and the previous configuration will be reestablished.
7.
The new flow time will be programmed by pulses (touches) in the Piezo lid. Every time you press it
the LED will blink.
According to the programmed time wished you can combine pulses at many levels or use only one level.
8.
If the desired flow time is less than 10 seconds it won't be necessary to pulse at adjustment levels 2
and 3 for example, for 5 seconds it will be enough 5 pulses at level 1) (h), afterwards, you'll have to wait (i)
for the LED to blink twice (j), then 3 times (m) and after blinking 4 times (p) you'll be out of the adjustment
mode. The SPOT tab will remain programmed with the desired flow time.
52//53