SPOT sanindusa 543637111 Mode D'emploi page 46

// OPERATION, PRE-INSTALLATION INFORMATION
Operation:
Ref. 5436371 | 5436381
To operate Perfect time, simply touch the designated area at the Piezo cap. Default flow time is 8
seconds. If you do not need more water, just touch the designated area again to stop the water flow
before the default flow time has passed.
Ref. 543381
This model features a permanent blue ring illumination. When a user has touched the piezo area in the
middle of the light, a flow cycle of 8 seconds will be completed. The blue light will blink while water runs
out of the faucet.
If the user does not need more water, he can touch the piezo area again to stop the water flow and the
blinking light before the default time was passed.
Check contents:
Separate all parts from packaging and check each part with the Pack contents section.
Make sure all parts are accounted for before discarding any packaging material. If any parts are missing,
do not attempt to install your Perfect time faucet until you obtain the missing parts.
Preparation for Installation:
Flush water supply lines thoroughly before installing the faucet. Do not allow dirt, Teflon tape or
metal particles to enter the faucet.
Shut off water supply.
Important:
All plumbing is to be installed in accordance with applicable codes and regulations.
46//47