Oven Light; Appliance Outlets (On Some Models); Troubleshooting - KitchenAid W10524728A Instructions D'utilisation

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
The 120-volt appliance outlet located on the control console may
be used to run portable appliances placed on countertops beside
the range.
The outlet operates independently and is not affected by range
control settings.
NOTE: Do not place portable appliances on the cooktop. Damage
to the portable appliance could result if the cooktop is hot.
First try the solutions suggested here or visit our website and reference the Customer Service section
Operation
PROBLEM
Nothing will operate
Cooktop will not operate
Excessive heat around
cookware on cooktop
Cooktop cooking results not
what expected
Oven will not operate
"FEATURE NOT AVAILABLE" is
displayed when trying to use
the Control Lock function.
Convection fan not working
Oven temperature too high or
too low
Oven indicator lights flash
18

Oven Light

Appliance Outlets

TROUBLESHOOTING

to possibly avoid the cost of a service call.
www.kitchenaid.ca
POSSIBLE CAUSES
Power supply cord is unplugged.
Household fuse is blown or a
circuit breaker is tripped.
Range is in Sabbath Mode.
The control knob is set
incorrectly.
The range is in Demo Mode.
Cookware that is not the proper
size
Control knob set to incorrect heat
level
Range is not level.
The electronic oven control was
set incorrectly.
Delay Start was set.
The oven control lockout is set.
The range is in Demo Mode.
A cooktop or oven function is
active, including the timer or
timed cooking features, or the
oven is hot or a cooktop hot
surface indicator is lit.
Oven door is open.
Oven temperature calibration
needs adjustment
Temperature has been changed
to Fahrenheit or Celsius.
Needs service (oven indicator
lights are flashing)
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
(on some models)
Appliance Outlet Circuit Breaker:
The circuit breaker for the appliance outlet on your range is located
next to the outlet. It is rated for 12 amps.
If the circuit breaker trips, it can be reset by pressing the switch. A
delay of several minutes may be required for the circuit breaker to
cool before it will reset.
SOLUTIONS
Plug into a grounded outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
See "Sabbath Mode" section.
Push in knob before turning to a setting.
Demo Mode will deactivate the Warm Zone element. See
"Demo Mode" in the "Electronic Oven Controls" section.
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ½" (1.3 cm) outside the cooking area.
See "Cooktop Use" section.
Level the range. See the Installation Instructions.
See "Electronic Oven Controls" section.
See "Cook Time" section.
See the control lock keypad feature in the "Feature Guide"
section.
Demo Mode will deactivate all heating elements. See "Demo
Mode" in the "Electronic Oven Controls" section.
Ensure that all cooktop and oven functions are off, and that the
cooktop and oven are cool. If this does not work, call for
service. See cover for contact information.
Close oven door. See "Convection Cooking" section.
See "Oven Temperature Offset Control" in the "Electronic Oven
Controls" section.
See "Fahrenheit and Celsius" in the "Electronic Oven Controls"
section.
See "Control Display" in the "Electronic Oven Controls"
section. If the indicator light(s) keeps flashing, call for service.
See cover for contact information.