Hendi 5000 D XL Mode D'emploi page 8

Error codes display
Error codes shown on the display (4)
E 1
E 2
E 3
Cleaning and Maintenance
Attention: Always unplug the appliance from the electrical power outlet and let it cool down completely
before cleaning and storage.
Cleaning
• Never immerse the appliance in water or other
liquids.
• Clean the cooled exterior surface with a slightly
damp cloth or sponge with some mild soap solu-
tion.
EN
Storage
• Before storage, always make sure the appliance
has already been disconnected from the electri-
cal outlet and cooled down completely.
Troubleshooting
If the appliance does not function properly, please
check the below table for the solution. If you are
still unable to solve the problem, please contact the
supplier/service provider.
Problems
The appliance does not switch ON.
Cooling fan is operating even after
the appliance is switched to Standby
mode.
8
Possible cause
The temperature of the appliance is
too high
Cooling fan defective
The pan or pot is overheated.
Possibly, the pan becomes empty and
appliance will shut down for protec-
tion.
The supply voltage is abnormal. (Sup-
ply voltage is too high or too low)
• Never use abrasive sponges or detergents, steel
wool or metallic utensils to clean the interior or
exterior parts of the appliance.
• Store the appliance in a cool, clean and dry place.
• Never put heavy objects on the heating surface
during storage as it may crack it.
• Error codes shown on the digital display (3). (See
--> Error codes display)
Possible cause
- Power plug is not connected proper-
ly with the electrical outlet.
- On/Standby (1) button is not pressed.
- This is normal. The cooling fan con-
tinues running in Standby mode for
some time to cool down all internal
elements.
Possible solution
Clear all obstacles that around the
appliance. Unplug the appliance, re-
move the pan or pot, wait until the ap-
pliance is completely cool down.
Contact the supplier.
Unplug the appliance, remove the
pan or pot, wait until the appliance is
completely cool down. And make sure
water is inside the pan.
Make sure that the appliance is con-
nected to a suitable electrical power
supply.
Possible solution
- Check the power plug to make sure
it is connected properly.
- Press the On/Standby (1) button to
start operation.
- Wait until the cooling fan stops ro-
tating.