Hendi 5000 D XL Mode D'emploi page 7

Operation
• Place a suitable cookware at the centre of the
heating surface of the appliance. (See --> Suita-
ble cooking equipment).
Note: Do not place empty cookware as this may
damage the cookware.
• Connect the internal wires of the power cord to a
suitable electrical supply outlet. (See --> power
supply line connection)
• Switch on the electrical supply system and On/
Standby indicator (1) will light up. The appliance
now in Standby mode.
• Then, switch On the appliance by pressing On/
Standby button (1) and " - - - -" will flash on the
display (3).
• Next, press increase setting (2) once. "3000" will
be displayed and this is the default power.
• Now, the appliance starts operating and you can
program in either power or temperature mode.
Setting Power level
• During operation, press the power / temperature
button (6) to activate. The indicator light (6) of the
power will light up.
• Press the increase setting (2) or decrease setting
button (5) to increase or decrease the power level
(Range: 100W ~ 5,000W). Default power is 3,000W.
Higher power level is suitable for steaming.
Note:
1. Press and hold the increase setting button (2) or
decrease setting button (5) for fast adjustment.
2. Every time, you press any button on the panel, a
short beep sound will be heard to alert the user.
3. After an extended period of operation, it is nor-
mal for the cooling fan inside to continue run-
ning in Standby mode for some time. Before
unplug the appliance, wait until the cooling fan
stops running.
Setting Temperature level
• During operation, press the power / temperature
button (6) to activate. The indicator light (6) of the
temperature will light up.
• Press the increase setting (2) or decrease setting
button (5) to increase or decrease the tempera-
ture level (Range: 35°C ~ 240°C). Default temper-
ature is 100°C. Higher temperature level is suita-
ble for roasting, grilling or frying.
Setting Timer
• After power or temperature setting for cooking,
you can opt for timer setting. Press the timer
button (4) to activate. The indicator light (4) with
light up.
• Press the increase setting (2) or decrease setting
button (5) to increase or decrease the operation
time (Range: 0 min ~ 180 mins). Default setting
is 0 min.
• When the timer is set, it will be stored automat-
ically within 5 seconds. The appliance will then
start operation. It will display the remaining time
and the power setting / temperature setting al-
ternately on the display (4).
• The appliance will go into Standby mode when
the set time is elapsed.
• If the set time is reduced to "0 min" manually,
the appliance will go into Standby mode instantly.
4. The appliance's surface is still hot after switch to
Standby mode. Wait completely cool down before
touching.
5. If no any button on the control panel is pressed
during operation for 2 hours, the appliance will
then switch to Standby mode automatically.
EN
7