Switching Your Ktc-500Dab On For The First Time; Switching Your Ktc-500Dab On And Off - Kenwood KTC-500DAB Mode D'emploi

Switching your KTC-500DAB on for the first time

After you've installed your KTC-500DAB, switch it on to finish setting it up.
1. Turn on your vehicle's ignition to make sure the antenna is switched on. After a few seconds, the wireless controller automatically
connects to the antenna. If not, see page 19.
2. Turn the Select dial to change the display language, then press the Select dial to choose it.
3. Turn and press the Select dial to choose how to connect your KTC-500DAB to your vehicle.
• If you've connected your KTC-500DAB with an auxiliary cable, choose 'LINE OUT'.
• If you're connecting your KTC-500DAB by FM radio, choose 'FM TRANSMIT' and then choose an FM frequency. Ensure a
radio station isn't using the frequency you choose.
Tune your vehicle's audio system to the same FM frequency as your KTC-500DAB. To easily find the FM frequency in
the future, save it as a preset on your vehicle's audio system.
After you've chosen how to connect your KTC-500DAB, it starts tuning to digital radio stations. When the autotune is complete, you can
start listening to digital radio.

Switching your KTC-500DAB on and off

• To switch on your KTC-500DAB, press .
• To put your KTC-500DAB in standby and use less power, press and hold .
Note: By default, the antenna automatically enters standby after 4 hours, and the screen on the wireless controller dims after
15 seconds. Read more about the display brightness on page 18.
12