Basic Operations; Overview; Switching Power On/ Off; Transceiver Password - Kenwood TK-7480 Mode D'emploi

O
VERVIEW
Your dealer can program your transceiver with Conventional, Voting, Voting with
Signaling, and Free Channel Call zones. The transceiver can handle up to 128
zones with up to 250 channels in each zone and a total combined maximum of
512 channels. Zones, channels, and their functions are programmed by your
dealer.
S P
WITCHING OWER
Press the switch to switch the transceiver ON.
• A beep sounds and the display momentarily lights up.
• If the Transceiver Password function is programmed, "
display. You must enter the password to unlock the transceiver. Refer to "Transceiver
Password", below.
Press the switch again to switch the transceiver OFF.
T P
■
RANSCEIVER
To enter the password:
1 Press the
2 Press the C> key to accept the entered digit and move to the next digit.
• Press the A key to delete an incorrect character. Press and hold the A key to
delete all entered characters.
• Repeat steps 1 and 2 to enter the entire password.
3 Press the S key to confirm the password.
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
To enter the password using a DTMF keypad:
1 Press the DTMF keys corresponding to the password digits.
• Press the DTMF # key to delete an incorrect character. Press and hold the
DTMF # key to delete all entered characters.
2 Press the DTMF
• If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
A V
DJUSTING THE
Press the key programmed as Volume Up to increase the volume and Volume
Down to decrease the volume.
8

BASIC OPERATIONS

ON/ OFF
ASSWORD
and keys to select a digit.
key to confirm the password.
OLUME
" appears on the