Selecting The Playback Source; Calling The Display Information; Setting The Time - Renkforce AN-8015BT Mode D'emploi

Selecting the Playback Source

Press button / MOD (6) to select the individual playback sources.
Selection takes place in the following order:
Radio > CD > USB > SD/MMC > AUX > BT AUDIO

If no CD, no USB memory, no SD/MMC card is inserted/plugged in or no Bluetooth source is connected,
the corresponding sources are skipped in the selection.

Calling the Display Information

The button 9 / DISP (22) can be used to call different information about the display (5), depending on operating mode.
Every push of a button will switch on the information type called. After 5 seconds, the display automatically switches
back to the basic display (first display in the list below).
When an RDS station is being received
Radio Mode
CD/USB/SD operation Time > Receiver frequency > Station name > Programme type > CD/USB/SD information
When no RDS-capable station is being received
Radio Mode
CD/USB/SD operation Time > Receiver frequency > PTY NONE > CD/USB/SD information

If the station does not transmit PTY information, PTY NONE is displayed.

Setting the Time

Keep the button 9 / DISP (22) pushed until the hour display for the time in the display flashes.
Set the hour display by turning the volume controller/selection controller (2).
Push the button 9 / DISP (22) briefly until the minutes display for the time in the display flashes.
Set the minutes display by turning the volume controller/selection controller (2).
Briefly push the button 9 / DISP (22) to save the setting.

When receiving an RDS station with time transmission, the time automatically adjusted. The manually
set time is then overwritten with the RDS time.
Time > Receiver frequency > Station name > Programme type
Time > Receiver frequency > PTY NONE
65