Removing And Replacing The Front Control Panel - Renkforce AN-8015BT Mode D'emploi

Removing and Replacing the Front Control Panel

The front control panel can be removed to prevent theft.
• Before you remove the front control panel, push the button
MUTE (1) for a long time to turn the product off.
• Press the button (7) to fold down the front operating unit.
• Hold the front operating unit on the right side, carefully push it to the left
to unlatch it and pull it from its holder.
• When you remove the front control panel, please put it into the supplied
protective cover.
• For replacing the control panel, place the left side into the holder as
illustrated in the figure below and press it carefully to the left until the
right side also latches in the holder.
• Fold the front operating unit back to the device until the latch latches
cleanly.
• Do not press on the display or the buttons.

Make sure to place the front operating unit on the device in the
correct direction and it latches cleanly in the holder.
Do not press the front operating unit against the unit too hard.
You can fold it closed just by pressing slightly on the device.
52
Operating Instructions

English
PWR/