Button Functions - Renkforce AN-8015BT Mode D'emploi

Button functions

• Buttons * / (8) and # /
With these buttons the receiving frequency can be changed to adjust stations in radio operation.
If a button is pushed briefly, the automatic station search is activated. The auto-scan only stops at the next station
that can be received well.
To switch off automatic station search and to manually adjust the receiver frequency keep the desired button pushed
until the display (5) shows MANUAL.

After some time, the devices switches back to automatic search; the display (5) briefly shows AUTO
then.
• Button AMS / 0 (10)
If you press this button briefly, the stations stored on the station storage buttons 1-6 (15) are played for about
5 seconds. To stop the auto-scan, press the button again.
When you keep the button pushed, all the stations that can be received well are stored on the station
buttons 1-6 (15).
After this procedure, the stored stations are played for about 5 seconds, as described above.
• Button BAND /
With this button you can select the band range of the radio unit. There are 3 FM and 2 MW areas available:
F1 > F2 > F3 > AM1 > AM2

On each of the 5 band ranges, 6 stations can be stored on the station button 1-6 (15).
• Station buttons 1-6 (15)
Short operation > direct selection of a previously stored station.
Long operation > the station currently received is saved to the respective station button.

Each one of the three FM ranges (F1-3) and the two AM ranges (MW1-2) has six station buttons.
Therefore you can assign 30 station buttons.
68
(9)
(11)
Operating Instructions

English