•
Button TA / 7 (19)
Short operation > TA function is switched on and off.
When you receive a traffic programme station, the display shows "TP" = traffic programme.
When the TA function is active, "TA" appears in the display.
After activation of the TA function, the receiver will start a search if no traffic announcement station is currently
received. The search stops at the next traffic announcement station that can be received well.
If a different audio source is being played (e.g. a CD ), the device switches to radio for the duration of a traffic
announcement.
When you listen to a radio program at a very low volume, the volume is automatically increased to an easily audible
level (see TAVOL in the "Menu settings"). When the traffic announcement is over, the volume you were hearing before
is restored.
With the TA-function active, the station search stops only for traffic announcement stations.
•
Button AF / 8 (20)
Short operation > AF function is switched on and off.
"AF" will be displayed if the function is active. If the reception of an RDS transmitter station gets weaker or the radio
does not receive and RDS station at all, the display flashes. When a station can be received well, the symbol is
displayed continuously.
When an RDS station is being received, the name of the station is displayed.
When you leave a transmission area, the radio can only switch to a better sender when the AF function is activated.
Long operation > Regional ID is switched on and off.
Push the button AF / 8 (20) for about 2 seconds until the display shows REG ON or REG OFF. Push the button again
longer to switch between these two operating modes. The normal display reappears automatically after a few
seconds.
If REG ON is on and the reception gets weaker, the radio only switches to a different frequency with exactly the same
program.
When the regional identification is off (REG OFF), and the reception gets weaker, the radio switches to a different
transmitter station with the same regional identification but a different programme.
69