Smartrail - Operation On The Touch Panel; How To Connect Smartrail; How To Put Smartrail Into Operation - Roco smartRail Manuel D'utilisation

Operation on touch panel
▶ Do not set up smartRail near radiators
or in places with direct sunlight!
▶ Do not set up smartRail in an envi-
ronment with major fl uctuations of
temperature and air humidity!
During operation, do not reach into the
infrared signals of the sensors! If the sensors
do not continuously measure the distance
of the locomotive, automatic length control
will trigger an Emergency Stop. Ensure that
the lenses are not touched or scratched.
smartRail automatically recognises whether
the locomotive runs on AC or DC when
reading out the locomotive address.
38
smartRail-Gebrauchsanleitung_19.11.indd 38
1. smartRail – Operation on the touch panel
The following pages will show you how to put smartRail into operation and how you control your
favourite locomotives on the integrated touch panel.

1.1 How to connect smartRail

1. Plug the supplied switching power supply (20V DC/52VA) into the bottom part of the smartRail.
2. Place smartRail on your desk, on a shelf or in a showcase, so that it is easily accessible.
3. Plug the switching power supply into the power socket. Ensure that you do not touch the touch
panel when plugging in or in the following 5 seconds, because the touch fi eld is calibrated when
started. In operation, the touch panel tunes to its environment.
" "
4. The key lights blue ("standby").
" "
5. To switch on, press the blue

1.2 How to put smartRail into operation

1a. If your locomotive has not yet been set on the rails, the
off ). smartRail indicates this way that you can now set your locomotive on the rails.
1b. Once the locomotive is set on the rails, the
" "
2. The red light of the key indicates that the locomotive on the rails was measured.
" "
3. Now press the key to read out the locomotive address. The scanning process is indicated by
sequential light of the light and function keys. Read-out takes a few seconds.
4. If the locomotive is not compatible for reading out or cannot be read out, smartRail will succes-
sively check all locomotive addresses. This may take several minutes.
5a. When the locomotive address is successfully read out the function keys and the direction keys
begin glowing in a dimmed white, they can now be activated. The left arrow
key will glow bright white. SmartRail is activated and ready to start.
key. The diode now glows white.
" "
key starts blinking (long on, short
" "
key glows red.
" " " "
and the
19.11.2012 11:03:55