Replacing The Power Cable - EINHELL TE-VC 1820 Mode D'emploi

Assembling the dirt bag (Fig. 7)
For vacuuming fi ne, dry dirt it is recommended
that you also fi t the dirt bag. This will ensure that
the pleated fi lter (15) does not fi ll up so quickly
and therefore help the vacuuming power last lon-
ger. In addition, it makes it easier to dispose of the
dust. Slip the dirt bag over the vacuuming hole.
The dirt bag is suitable for dry-vacuuming only.
5.3 Fitting the suction hose (Fig. 1/8)
Connect the suction hose (11) to the correspon-
ding connector on the wet and dry vacuum clea-
ner, depending on the application required .
Vacuuming
Connect the suction hose (11) to the suction hose
connector (9).
Blowing
Connect the suction hose (11) to the blow con-
nector (10).
Air regulator (Fig. 2)
The air regulator (17) can be fi tted between the
suction hose (11) and the suction tube (20). The
suction power of the nozzle can be infi nitely ad-
justed using the air regulator (17).
When wet vacuuming, make selective use of the
air regulator to suck in air as well as liquids. This
will help to take some strain off the equipment
when vacuuming liquids.
5.4 Suction nozzles
Dual-purpose nozzle (Fig. 1/2)
For dry vacuuming surfaces use the dual-purpose
nozzle (13).
Crevice nozzle (Fig. 1/2)
The crevice nozzle (19) is designed for vacu-
uming solids and liquids in corners, edges and
other areas that are diffi cult to access.
Upholstery nozzle (Fig. 1/2)
For cleaning upholstery use the upholstery nozzle
(12).
5.5 Accessory holder (Fig. 3)
The wet and dry cleaner is equipped with a holder
for the space-saving storage of vacuum nozzles.
Anl_TE_VC_1820_SPK9.indb 14 Anl_TE_VC_1820_SPK9.indb 14
GB
6. Operation
6.1 ON/OFF switch (Fig. 1)
Switch position 0:
Switch position I:
6.2 Dry vacuuming
For dry-vacuuming, use the pleated fi lter (15). In
addition, you can also fi t the dirt bag. (see point
5.2)
Always ensure that the fi lters are perfectly secure.
6.3 Wet vacuuming
For wet-vacuuming, use the foam fi lter (16) (see
point 5.2).
Check that the fi lter is securely fi tted at all times.
When wet vacuuming, the fl oating safety switch
(5) closes when the maximum tank level is
reached. In doing so, the suction noise of the
equipment will change and become louder.
You must then switch off the equipment and em-
pty the tank.
Danger!
The wet and dry vacuum cleaner is not suitable
for the vacuuming of combustible liquids.
For wet vacuuming, use only the supplied foam
fi lter.
6.4 Blowing
Connect the suction hose (11) to the blow con-
nector (10) on the wet and dry vacuum cleaner.

7. Replacing the power cable

Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
- 14 -
Off
On
06.05.2019 15:26:48 06.05.2019 15:26:48