Toll-Free Order Fax: 08 00. 7 86; Area Of Application; Operation; Cleaning And Maintenance - Storch ProCut multi Mode D'emploi

The device possesses a voltage range which can pose an electrical hazard to humans and
animals in the event of certain unfavourable conditions. It should only be unscrewed and / or
disassembled by authorised personnel. Similarly, maintenance and repair work should only be
conducted by electrical specialists and authorised service centres. The buyer / user operates
the device at their own risk and under their own responsibility.
Application area
This device is intended exclusively for cutting rigid polystyrene foam (styrofoam).

Operation

This device should only be used by an instructed person who is familiar with its operation. Use of suitable
work clothing and protective gloves is recommended. (Also refer to the section entitled "Safety precau-
tions"). If the device is going to be used indoors, it should only be operated in areas that are adequately
ventilated. The device operates with low voltage and it should only be used with the connected special
transformer.
The device must only be operated with the original cutting wire (d = 0.7 mm). If you will be interrupting work for more
than 3 minutes, switch off the device.

Cleaning and maintenance

Before starting to use the device all nuts and bolts must be checked and re-tightened if necessary. Wire guide rollers
and pullout elements are to be cleaned and checked for free movement. If it is heavily contaminated (incrustation), the
cutting wire must be replaced.

Safety information

Protect the device from moisture. Outdoor operation in the rain is prohibited. Only use dry utensils when
cleaning; do not use any cleaning agents that contain solvents.
Smoke is generated during the cutting process. This contains an extremely low amount of styrene, which
is far below the prescribed limit.
The wire gets very hot. If it comes into contact with the skin, it will inevitably result in burns. Use of
protective gloves is recommended. The wire is subjected to mechanical tension (spring force). If the hot
wire ruptures, it can generate sparks. The use of protective goggles is therefore recommended. The hot
wire (ignition source) represents a fire hazard; make sure any flammable objects are maintained at a safe
distance.
If the connecting cable (or plug) is damaged, it must be replaced immediately. Repairs to electrical com-
ponents should only be conducted by an electrician or a STORCH service centre!
Before replacing the cutting wire the device must be disconnected from the power socket!
Only use special STORCH replacement cutting wire (d = 0.7 mm), art. no. 57 00 46. The use of other
wires can damage the device or the transformer and result in subsequent damage.
When connected to the power supply the transformer generates heat, even when the device is switched
off. Make sure that this heat can be emitted freely and that it does not affect any heat-sensitive objects,
otherwise these could be turned into a potential source of danger.
43