No-Frost Technology; Regular Cleaning; When The Refrigerator Is Not In Use; Trouble Shooting - Electrolux EUF 10003 W Mode D'emploi

30 electrolux

No-Frost technology

In order to facilitate the removal of the ice
layer, the evaporator is assisted by
electric heating during the defrosting
procedure. The ventilator is in OFF
position. The defrost water will drip in the
tray placed at the compressor and will
evaporate. In the course of the defrosting
procedure (approx. 30 minutes) the
evaporator becomes warm but it has no
influence on the internal temperature.
The foods should be kept well-packed in
order to avoid any moisture loss as a
result of air circulation.
Do not obstruct the vent holes because
otherwise the operability of the product
may be compromised.
For such purpose it is recommended to
put all foods in the baskets in the freezer
compartment.

Regular cleaning

It is practical to clean the inside of the
freezer and defrost it at a time.
Household cleaner or soap must not
be used.
After breaking the circuit wash the
appliance using lukewarm water and
wipe it.
Clean the door gasket with clean
water.
After cleaning apply voltage to the
appliance.
It is recommended to remove the dust
and dirt collected on the back of the
appliance and the condenser once or
twice a year.
GB

When the refrigerator is not in use

If you do not use the product for longer
periods, make sure to perform the
following:
Set the thermostat to position <<
Disconnect the product from the
mains.
Remove all foods from the product.
Perform defrosting and cleaning
operations as described above.
Leave the doors ajar to avoid the
build-up of unpleasant odors.

Trouble shooting

During operation of the appliance
some smaller but annoying trouble
can often occur, which does not
require calling a technician out. In the
following chart information is given
about them to avoid unnecessary
charges on service.
We draw your attention that operation
of appliance goes with certain sounds
(compressor- and circulating sound).
This is not trouble, but means normal
operation.
We draw it to your attention
again that
operates discontinuously, so the
stopping of compressor does not
mean being no-current. That is why
you must not touch the electrical parts
of the appliance before removing it
from the mains socket.
>>.
the appliance