MRA 4025066140602 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
2 Domed screws M5 x 30
2 Domed screws M5 x 20
4 Plastic washer 12 x 5
2 Spacer 20 x 10
2 Spacer 20 x 3
1 Edge protection and clamps
Fitting the screen to the motorcycle:
1. Position the motorcycle on a level surface.
2. Unscrew the original screws and remove the fairing screen (P1 & P2).
3. Fit the MRA fairing screen using the screws, washers and distance sleeves supplied.
4. Secure the screen first of all at the two lower mounting points using the long screws
and the 10mm distance sleeves (give them two to three turns). Following this, secure
the upper mounting points using the short screws and the 3mm distance sleeves.
Then tighten all of the screws firmly.
5. It is also possible to push the clamping sleeves over the ends of the protective edge
strip and lightly compress these using a pair of pliers to secure the edge strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW F700GS
Article No..
--- Allen key 3mm
10566 Torx 25
10673
10635
10455
10881
3
Required tools