Replacing The Battery In The Wsh 20 Sensor Tap; Supplement "Touch Settings And Programming" On; Cleaning, Care And Maintenance - Stiebel Eltron WSH 10 Utilisation Et Installation

operATIoN
Cleaning, care and maintenance
5.2 Replacing the battery in the WSH 20 sensor tap
A
2,5
C
2,5
Note
The sensor tap is powered by a lithium battery.
Remove spent batteries. Leaking batteries cause damage
which is excluded from any warranty. Non-rechargeable
batteries must not be recharged.
Never use rechargeable batteries.
If the sensor tap is not going to be used for an extended
period, remove the battery.
Battery disposal
Never dispose of batteries with domestic waste. Spent
batteries may contain noxious substances that can be det-
rimental to the environment and human health. Dispose
of batteries through your dealer or via a central recycling
point for special waste.
5.3 Supplement "Touch settings and
programming" on the internet
Note
You can also find separate instructions for
"Touch settings and programming" for the
sensor tap on the internet. To view this,
scan the QR code or paste this link into
your browser: www.stiebel-eltron.de/
sensorarmaturen
We recommend that you:
f Print out the instructions and laminate them. f
f Position the instructions close to the sensor tap. f
www.stiebel-eltron.com
B
D
10 sec.
6.

Cleaning, care and maintenance

f Never use abrasive or corrosive cleaning agents or abrasive f
sponges.
f If the sensor tap is dirty or covered in limescale, clean it with f
soapy water or diluted domestic vinegar, then rinse with
plenty of clean water. Dry the sensor tap with a cloth.
f For descaling, remove the aerator from the fitting. To avoid f
inadvertently triggering the flow of water, activate a draw-off
pause; see chapter „Extended settings / Setting the draw-off
pause / Activating the draw-off pause".
WSH 10 | WSH 20 | 19