Standard Settings; Extended Settings - Stiebel Eltron WSH 10 Utilisation Et Installation

operATIoN
Settings
Symbols
Symbol Description
Touch the touch area
Move your finger away from the touch area
The LED on the sensor flashes
Water is running from the tap
The water flow has been interrupted
4.3

Standard settings

4.3.1 Setting the water run-on time
The water run-on time can be set between 0 and 10 seconds.
Factory setting: approx. 1 second
2 s 1x
5 s 1x/1x
0-10 s
0-10 s
1x
16 | WSH 10 | WSH 20
f Touch the touch area for 2 sec- f
onds. The green LED lights up
once.
f Touch the touch area for 5 sec- f
onds. The green LED flashes
briefly. The red LED flashes
once.
f Keep your finger on the touch f
area for the period of time you
want the water to run on for.
Water runs while you make
the setting.
Setting: 1 - 10 seconds = water
run-on time.
f If you move your finger away f
from the touch area, the green
LED lights up once to confirm.
4.3.2 Adjusting the sensor range
The sensor range can be adjusted to suit the washbasin. This
prevents the sensor tap from running independently.
Factory setting: distance 6
1x
2 s
2x 2x/1x
15 s 4x
...x
8x
7x
6 x Factory setting
5x
4x
3x
2x
1x
4.4

Extended settings

4.4.1 Setting the draw-off pause
You can interrupt the flow of water for approx. 2 minutes to be able
to clean the sensor tap and washbasin, etc., without inadvertently
triggering the flow of water.
Activating the draw-off pause
2 s 1x
2x 2x/1x
...
f Touch the touch area for 2 sec- f
onds. The green LED lights up
once.
f Touch the touch area briefly f
twice (0.5 seconds). The green
LED gives two short flashes
and one long flash. The red
LED pulses.
f Hold your finger on the touch f
area (ignore the red LED
which flashes four times after
5 seconds). After approx.
15 seconds, the red LED flash-
es one to eight times, indicat-
ing distances 1 - 8.
f Move your finger away from f
the touch area. The red LED
flashes according to the se-
lected distance.
f Wait approx. 10 seconds until f
the setting has been complet-
ed. The green LED lights up
once to confirm.
f Touch the touch area for 2 sec- f
onds. The green LED lights up
once.
f Touch the touch area briefly f
twice (0.5 seconds). The green
LED gives two short flashes.
The red LED pulses.
f The flow of water is interrupt- f
ed for 2 minutes. The red LED
pulses.
www.stiebel-eltron.com