Cleaning The Spray Lance; Maintenance; Mechanical Maintenance; Electrical Maintenance - Titan PowrPlast 600 Mode D'emploi

GB

maIntenance

8.3

cLeANING tHe SPRAy LANce

• Clean the texture tip.
• Use cleaning needles to clean the air holes in the texture
tip.
• Clean and lubricate the O-ring (fig. 20, 1).
• Clean the spray lance and material tube on the inside using
a bottle brush (0342 329).
• Clean all threads thoroughly.
• Rinse the spray lance with clear water. Open and close the
material tap three times as you are doing this.

1
9
MAINteNANce
ATTENTION! It is imperative that the machine be
deenergized by unplugging the plug before all
work and maintenance work. Otherwise there is
a danger of short-circuiting!
Repairs may only be carried out by qualified per-
sonnel who dispose the corresponding training
and experience. The device must be tested by a
skilled electrician after every repair.
The mortar spraying machine is designed so that a minimum
of care and maintenance is required. However, the following
work has to be carried out and components checked regu-
larly:
9.1

MecHANIcAL MAINteNANce

• Keep the thread at the pump tube and pump housing
clean and, if appropriate, seal.
• Check the seals at all the couplings and connecting pieces
for leaks. If appropriate, replace worn seals.
• Check the following for damage before every usage:
- Mortar hose
- Power cable
- Control unit
- Remote control connection cable (if present)
• Check the suction system for leaks during every usage.
46
9.2

eLectRIcAL MAINteNANce

• The electrical drive and its ventilation slots must always be
kept clean and may not be cleaned with water. Danger of
short-circuits.
9.3

LONG PeRIODS OF NON-uSAGe

If the mortar spraying machine is not used for a longer period,
it has to be cleaned thoroughly and protected against corro-
sion.
Remove pump unit so that rotor cannot seize
on stator.
9.4
ROtOR RePLAceMeNt (FIG. 21)
• Loosen fixing screw (1) and remove old rotor (2).
• Fit new rotor with new fixing screw.
• Glue fixing screw with Loctite 243.
Note: use Loctite 243 only.
PowrPlast 600
1
2