Beginning Of The Spraying Process; End Of The Spraying Process - Titan PowrPlast 600 Mode D'emploi

PowrPlast 600
6.8.2
RINSe tHe MORtAR HOSe
(PNeuMAtIc SPRAy LANce)
• Switch off compressor.
Do not bend the mortar hose!
Protect it against damage, for exam-
ple against being driven over as well as
against sharp objects and edges.
• Hold the spray lance over the container.
• Set selector switch to "F".
• Open material tap (Fig. 18, 1) on spray lance. (Material tap at
90° to spray lance)
• If cellulose paste comes out of the tip, close the material tap
(fig. 18, 1) (material tap points forwards).
• Set selector switch to "A".
• Replace container and lubricant with container and coating
material.
• Hold spray lance above container with cellulose paste.
• Set selector switch to "F".
• Open material tap (Fig. 18, 1) on spray lance.
• As soon as coating material exits from spray lance, close ma-
terial tap (Fig. 18, 1).
• Set selector switch to "A".
• Switch on compressor.
The mortar spraying machine is now full and ready.
6.9

BeGINNING OF tHe SPRAyING PROceSS

• Open the air flow regulator (fig. 18, 3) and the material tap
(18, 1) at the spray lance.
• Adjust the flow of material with the delivery volume con-
troller (fig. 18, 2) on the control unit and set the air quantity
by adjusting the air flow regulator (fig. 18.3) to attain the
desired spray pattern.
Important: Do not let the mortar spraying
machine run dry. Switch the device off im-
mediately if no more material comes out of
the tip or if the spray line becomes irregu-
lar. Possible reasons for the problem and
how to correct it can be found in the chap-
ter called „eliminating faults".
Increased material tap wear. Do not use the
material tap to set the material volume.
the delivery volume controller should be
used for this purpose.
6.10

eND OF tHe SPRAyING PROceSS

• Close the material tap (Fig. 18, 1).
• Close the air flow regulator (fig. 18.3).
Always close material tap at end of the
spray process.

3
2
commIssIonIng
1
POWER
ERROR
A
R F
GB
43