Connecting The Mortar Hose; Automatic Spray Lance; Pneumatic Spray Lance; Compressor (Accessory) - Titan PowrPlast 600 Mode D'emploi

GB
commIssIonIng
6.3

cONNectING tHe MORtAR HOSe

6.3.1

AutOMAtIc SPRAy LANce

• Check that the pump unit is seated firmly.
• Connect the mortar hose (Fig. 7, 1) and secure it with the
clamping levers (Fig. 7, 2).
• Connect the atomizing air connection at the mortar hose
to the compressed air supply, for example the compressor
(accessory).
6.3.2

PNeuMAtIc SPRAy LANce

• Check that the pump unit is seated firmly.
• Connect mortar hose (Fig. 7, 1) and secure with clamping
levers (Fig. 7, 2).
• Connect atomising air connection on mortar hose to front
connection on handle (Fig. 8,1) and compressor air hose (ac-
cessory) to rear connection on handle (Fig. 8,2).
6.4

cOMPReSSOR (AcceSSORy)

Place the compressor at a secure location next to the mortar
spraying machine and connect it to the mains network.
Note:
Only operate the compressor in accordance with the enclosed
operating manual.
6.5

SPRAy AttAcHMeNt ASSeMBLy (AcceSSORIeS)

Different accessories can be mounted to the
spray lance, depending on the application,
e.g. an extension can be attached. A precise
overview can be found in the "Accessories"
chapter.
• Disengage the quick connector and pull the air hose (fig. 9,
1) out of the lance.
• Loosen the locknut (2) and remove the material hose (3).
• Insert the material hose and air hose (if available), which
are part of the accessory, into the spray lance and secure
by tightening the locknut. (Fig. 10)
Attention: Make sure the O-ring (fig. 10, 4) is not dam-
aged.
40

1

2


4
PowrPlast 600
2
1
2
3
1