Setting Subwoofer Controls Using The App - With Lfe Connection - Paradigm Defiance Série Manuel Du Propriétaire

SETTING SUBWOOFER CONTROLS
Using The App — With LFE Connection
1. Turn the Level control completely counter clockwise to its minimum.
2. Turn the Low Pass Filter control to Bypass.
3. Turn the Phase control to 0° (completely counter clockwise).
4. Listen to a bass music or video selection while seated in your primary
listening area and turn up the Level control until the subwoofer can
be clearly heard.
5. Rotate the Phase control until you hear the most bass. Your
subwoofer and front speakers are now in phase. Do not change
phase alignment again unless you move the subwoofer or front
speakers to a different location in your room, or move or remove any
large items of furniture or room furnishings (i.e. carpet, draperies, etc.)
6. Turn the Level control completely counter clockwise to its minimum.
7. Slowly rotate the Level control until you match the subwoofer's
volume with the Volume of your front speakers. Bass should be
clearly audible, but not intrusive.
NOTE: If you happen to have an SPL meter, set the meter to 80, SLOW
and C weighted. Then enable the subwoofer test tones on your receiver/
preamplifier. With this set repeat Step 7 until the meter reads 75dB.
25