Paradigm Defiance Série Manuel Du Propriétaire page 23

7. Line Level Input (Left/Right)
The Line Level Input can be used as a subwoofer connection to the
Main-Out or Pre-Out on a receiver/preamplifier.
NOTE: The setting of the Low Pass Filter control is applied to the signal
received through these inputs.
8. Line Level Input (LFE)
The Line Level LFE Input can be used as a subwoofer connection to to
the LFE Out/Sub-Out on a receiver/preamplifier.
NOTE: The Low Pass Filter should be set to Bypass. LFE signals are
controlled from your receiver/preamplifier. By default, the Low Pass Filter
is set to Bypass.
9. Balanced XLR (LFE) (X15 only)
The Balanced XLR LFE Input can be used as a subwoofer connection to
the LFE Out/Sub-Out on a receiver/preamplifier.
10. Speaker Level Inputs (Left/Right)
The Speaker Level Inputs allows standard speaker cable be used for
the subwoofer connection. To use these connections the speaker cable
should be terminated using banana style plugs.
NOTE: The setting of the Low Pass Filter control is applied to the signal
received through these inputs.
11. Defiance WT Wireless Module Input (Sold Separately)
The Defiance WT Wireless Module allows for wireless subwoofer integration.
NOTE: The Wireless Module must be paired with its matching transmitter
– See the Paradigm Defiance WT Manual.
12. AC Power Connection
WARNING! The power cord should not be
installed, removed, or left detached from the
subwoofer while the other end is connected to
an AC power source.
The IEC power cord should be firmly inserted into the AC power
receptacle on the rear panel of the subwoofer. Then to any convenient
AC wall outlet.
NOTE: The sub also integrates a signal sensing power supply that
automatically switches off after sensing no music signal for several
minutes (this will only occur when the power switch is set to 'Auto').
p a r a d i g m . c o m
20