Paradigm Defiance Série Manuel Du Propriétaire page 22

CONTROLS & CONNECTIONS (cont'd)
3. ARC Input
The ARC USB connection is used to connect the subwoofer to PC/
Laptop when running Anthem Room Correction (ARC).
NOTE: Not required when running ARC via Bluetooth.
4. Status Indicator
The subwoofers is equipped with a multi-colored LED, (located on the
rear) which indicates the current status of the subwoofer
• No illumination — Subwoofer is not on.
• White — Subwoofer is on
• Red — Subwoofer is in 'Standby mode'
• Flashing — Subwoofer has detected an error code.
5. Power Mode
The Power Mode switch allows you to control how the subwoofer turns
On & Off.
• Auto — When set to "Auto", the subwoofer will turn on when an
audio signal is detected.
NOTE: After several minutes of inactivity the subwoofer will enter
Standby Mode.
NOTE: If the subwoofer enters Standby Mode during quiet or
low level audio playback, this is likely due to a low audio output
signal from the audio system. Increasing the system volume should
resume normal subwoofer playback. Increasing the subwoofer
output level on the receiver/preamplifier and decreasing the level on
the subwoofer will solve this issue in the future for similar listening levels.
• On — When set to "On", the subwoofer will always be on.
• Trigger — When set to Trigger, the subwoofer will power on once a
12V signal is received from the 3.5mm trigger connection.
6. Trigger In
The 3.5mm trigger input
on signal from the receiver/preamplifier.
19
(stereo or mono) allows for a dedicated power