Power Fist 79cc OHV Manuel D'utilisation page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

V 4.0
c.
Remove the dipstick and check that the oil is between the Full
and Fill marks. Add or drain oil based on the measurement.
d.
Reinsert the dipstick and either press firmly to hold in place
or screw the oil fill cap hand tight
HOW TO ADD OIL
IMPORTANT! Read the Engine Oil section before adding oil to
ensure that it is suitable for the engine.
1.
Remove the oil filler cap (K) and place to one side.
2.
Place a funnel into the oil fill neck. The funnel
opening should be wide enough to prevent the
oil from collecting in the funnel's cone.
3.
Pour oil into the funnel. Allow the oil to settle
for one minute and recheck the level.
Repeat until the desired level is reached.
4.
Insert and hand tighten the oil filler cap.
5.
Wipe up any spilled oil. Dispose of oil soaked
rags in a proper hazardous waste container.
HOW TO DRAIN OIL
WARNING! Draining oil from the engine may involve tipping it on the
side. This can cause fuel to leak into the oil compartment, creating a
potential fire hazard. Do not tip the engine while draining. If this is
unavoidable, drain the fuel from the engine before draining the oil.
1.
Remove the dipstick (K).
2.
Place an approved container below the oil drain plug.
3.
Remove the oil drain plug and allow oil to the drain
into the approved container.
4.
Install oil drain plug and tighten with a wrench.
IMPORTANT! Used oil must be disposed of properly. Do not pour it
on the ground, down a drain or throw it in the trash. Take the oil to
your local recycling centre or a service station for reclamation.
Visit www.princessauto.com for more information
79cc OHV Gas Engine
Fig. 5
13

Publicité

Table des Matières
loading

Table des Matières