Technical Informatio; Functions - Marklin Digital 60965 Manuel D'instructions

Technical Information
• Continuous current load at the motor output ≤ 1.1 amps
• Current load at the light outputs
• Current load at AUX 1 – AUX 2 each
• Current load at AUX + lights (total)
• Current load for motor and AUX 5/6
• Maximum total load
• Maximum voltage
• Sound performance (at 4 Ω /8 Ω) 2.3 watts / 1.2 watts
• Short circuit and overload protection at the outputs lights
front (LV), lights rear (LH), AUX 1 – AUX 2 and at the motor
outputs.

Functions

The mSD SoundDecoder is a sound decoder with very
extensive setting and adaptation possibilities. Additional
sound functions are available. This decoder can be updated.
The requirement for this is an appropriate controller
(60213/60214/60215 Central Station, software Version 2.0,
track format processor GFP 2.0 or higher).
The settings and digital functions can only be used in digital
operation. However, the same possibilities are not available
in all protocols.
These instructions describe the installation and the possible
settings for the 60948 and 60949 decoders. Unless otherwise
stated, the functions refer to both decoders.
• Capable of multi-protocols (fx (MM), mfx, DCC, and AC/DC).
• Automatic system recognition. The address assigned to
each system must be used for operation.
26
• Acceleration and braking delay can be set separately
≤ 250 milliamps
• Typical sound backdrops for diesel and electric locomo-
≤ 250 milliamps
≤ 300 milliamps
• Variable motor feedback control is available in digital as
≤ 1.1 amps
≤ 1.6 amps
• 6090, 60901, DC, and can motors with bell-shaped arma-
≤ 40 volts
• Function mapping included.
• Can be updated with the CS2 (Software 2.0, track format
• Programming on the Main (PoM) this type of program-
• Switching range can be set.
• Braking / signal stopping block recognition is available in
from each other. Any function button desired can be as-
signed using the function mapping.
tives are included.
well as in analog operation.
tures are supported. See necessarily this table on page
23. These locomotives can not be converted this set.
processor GFP 2.0 or higher).
ming must be supported by the controller. Please note the
instructions for your controller when doing this.
digital operation.