Spypoint FL-8 Manuel D'utilisation page 5

8 9
VIDEO
Allows you to take videos. When the «video» mode is selected, the
test light in the front of the camera (see above) will fl ash for 60
seconds to allow the user to leave the area without being videoed.
MS-1 activated
Note: Video available at night with the IR unit only.
SET/TEST
.
Allows the user to test the detection system of the camera When
the «SET/TEST» mode is selected, no picture or video is recorded.
Walk perpendicularly in front of the camera. When the camera
detects movement, the light blinks to indicate that normally, a
photo or video would be recorded. If the system does not detect
the movement, increase the distance detection using the wheel
IRB-W activated
«DISTANCE» or realign the system differently. When you
understand how the device responds to detections, you can better
adjust the direction or the height of the installation.
How to properly install your camera
using the supplied installation strap:
RC-1 activated
(Recommended installation height: about 3 feet).
VIEW
Allows the user to view photos and videos directly on a TV set.
Turn «OFF» your camera and select «VIEW». Connect the yellow
end of the audio-video cable (supplied) into the «VIDEO IN» of
the TV and the other end into the «TV OUT» of the camera. Turn
«ON» the camera. You will see the last picture or video recorded
by your system. To change the picture or the video, use the key
«UP» or «DOWN». If you press «MENU/OK», the following
options will appear:
Test light