HBM WE2111 Mode D'emploi page 15

WE2111
A3983-1.0 en/de/fr
Fig. 5.2 View from rear, connection of optional modules
"
Hand-tighten the two fastening screws for the module
(Fig. 5.2).
The module is then ready for operation.
Depending on the module type, settings may need to be
implemented, e.g. which input/output should be used and
how. Further information can be found in the Operating
Manual.
Use shielded cables for the analog outputs. The cables
for the digital inputs/outputs only need to be shielded if
the cable length exceeds 30 m.
Fastening screws
15