Before First Use; Product Description - Adler europe AD 7714 Mode D'emploi

II. WARNINGS
1. Never use the device if it is damaged or does not function properly.
2. Never use the device if it has fallen from a height before and shows visible signs of
damage.
3. Do not use extension cords or other electrical outlets that do not meet the applicable
standards and electrical regulations.
4. Any repairs, dismantling or replacement of any parts should always be made by a
specialized facility.
5. If the device and elements such as electrical contacts are wet, the plug or cable should be
dried before using the device and its components.
6. Do not use the device with wet hands.
7. When there is a risk that the device has been damaged NEVER try to repair the device
yourself.
8. Never wash the device under running water or in such a way that water drips into it.
9. Do not use accessories that are not recommended by the manufacturer. They may pose a
danger to the user and may cause damage to the device.
10. Ensure that the device has cooled down before storing.
11. Do not touch the housing during use. During operation, use only knobs and switches.
After switching off, wait for the device to cool down.
12. CAUTION: Some parts of this device may become very hot during operation and cause
burns.
III. BEFORE FIRST USE
1. Remove all packing material and straighten the power cord
2. During installation, in no case may the device be covered with insulating material or similar material
3. When assembling the device, beams and rafters should not be cut or cut
4. Before first use read all instructions for use.
5. Check if the voltage listed on the product ratting label corresponds to the voltage of the power network in your home
INSTALATION
Use drill to drill two holes in the wall, minimum 180 cm from the floor and 20 cm from ceiling - picture A. Once you have drilled the holes,
insert the pad and screw. Make sure the screws are well tightened then hang the device on the wall.

PRODUCT DESCRIPTION

Picture B. MAIN SWITCH
ON/OFF = TURN ON /TURN OFF.
Picture C. REMOTE CONTROLER
1. ON/OFF button
4.CLOCK
8. + -> Button for raising the temperature. Also serves as selection button for time/day.
9. - -> Button for lowering the temperature. Also serves as selection button for time/day
Picture D. LED PANEL
1. ON symbol
3. Heating power 2000W
5. Temperature display
7. Time display
9. OFF symbol – timer shutdown
2. MODE
5. SET UP
2. Heating power 1000W
4. AUTO function
6 .Day display
8. ON symbol – timer start up
10. Open window detection function
3. DAY
6. WEEK/TIMER
7
7. MIN
10. RESET - Timer reset button