Cleaning The Lint Screen; Removing Accumulated Lint From Inside The Dryer Cabinet - Whirlpool LGQ8000HQ0 Guide D'utilisation Et D'entretien

C
ARING FOR
C
LEANING THE LINT SCREEN
Every load cleaning
The lint screen is located under a lid on top of the
dryer. Clean it before starting each load. A screen
blocked by lint can increase drying time.
To clean:
1.
Open the lid and pull the lint screen towards
2.
Roll lint off the screen with your fingers. Do not
3.
Push the lint screen firmly back into place and
close the lid.
IMPORTANT:
•
Do not run the dryer with the lint screen loose,
damaged, blocked, or missing. Doing so can
cause overheating and damage to both the dryer
and fabrics.
R
EMOVING ACCUMULATED LINT FROM INSIDE THE DRYER CABINET
Lint can gather inside the dryer and be a fuel for
fire. Lint should be removed every 2 years, or more
often, depending on dryer usage. Cleaning should
be done by a qualified person.
Y D
OUR RYER
you.
rinse or wash screen to
remove lint. Wet lint is
hard to remove.
•
Some towels made of synthetic fibers and natu-
ral fibers (polyester and cotton blends) may shed
more lint than other towels, causing your dryer's
lint screen to fill up faster. Be sure to remove
lint from the lint screen before and after drying
new towels.
•
If lint falls off the screen during removal and into
the dryer, check the exhaust hood and remove
the lint (see "Checking Your Vent").
As needed cleaning
Laundry detergents and fabric softeners can cause
a residue buildup on the lint screen. This buildup
can cause longer drying times for your clothes, or
cause the dryer to stop before your load is com-
pletely dry. You may be able to see this buildup,
or the lint may be falling off the screen because it
is clogged.
Clean the lint screen with a nylon brush every six
months or more frequently if it becomes clogged
due to a residue buildup.
Use the following method:
1.
Wet both sides of lint screen with hot water.
2.
Wet a nylon brush with hot water and liquid
3.
Rinse screen with hot water.
4.
Thoroughly dry lint screen with a clean towel;
replace in dryer.
detergent; scrub lint
screen with the brush
to remove residue
buildup.
13