Natural Vent Adaptations; Combustion Air - Continental Fireplaces CDVS500N Instructions D'installation Et D'opération

4.3.5 NATURAL VENT ADAPTATIONS

Refer to "DOOR OPENING AND CLOSING" section
prior to proceeding to prevent damaging the appliance.
Remove both burners and the log support
A.
bracket.
B. Remove the combustion air cover plate and its
gasket. THE TWO SCREWS MUST BE RE-
SECURED.
Undo the bracket holding the thermodisc, turn
C.
90° as shown and reattach to the weld stud
located on the right air manifold side.
NOTE: Do not tighten the wing nut until
burner is installed; then ensure that the
thermodisc firmly touches the underside of
the burner tray and tighten. This enables the
blower to function properly.
Secure the terminal block into place as shown
D.
with the screw supplied.
E. Gently pull the two white spill switch wires
to take up any slack. Feed these wires down
through the combustion air opening and back
up through the 4x6 inch cut-out in the base.
Connect the shorter of the 2 wires to the
terminal block.
Disconnect the black on/off switch wire from
F.
the terminal #1 (TH) of the gas valve and attach
it to the 3/16" tab to the other side of the
terminal block. Connect the remaining wires (1
black - 1 white) with 1/4" connectors to TP/TH
(3) and TH (1) on the gas valve.
Replace and re-secure the log support bracket
G.
and the two burners ensuring that each venturi
fits over the burner orifice.

4.3.6 COMBUSTION AIR

ANY APPLIANCE NEEDS AIR FOR SAFE OPERATION AND MUST BE INSTALLED IN SUCH A WAY
THAT ADEQUATE COMBUSTION AIR IS AVAILABLE. THIS APPLIANCE IS DESIGNED TO FUNCTION
If using outside air, connections can be made through a hole in the floor to line up with the hole in the pedestal
base. Use a fresh air kit available through your local authorized dealer / distributor. Secure the 4" (102mm)
diameter aluminum liner to the hole in the base of the pedestal. Avoid cutting away floor joist, electrical wiring
or plumbing. Seal around the outside pipe with insulation to prevent drafts.
WARNING
!
USING EITHER OUTSIDE OR INSIDE (ROOM) AIR.
LOG SUPPORT BRACKETS
REAR BURNER
FRONT BURNER
COMBUSTION AIR
COVER PLATE
W415-1430 / B / 07.31.18
27
EN
TURBO
VIEWING
MIRROR