BaByliss PRO X2 VOLARE maxlife PRO FX811E Mode D'emploi page 9

BEFORE USE
This clipper is designed for professional use to trim hair and beards. Charge it for
3 hours before use for the first time in order to activate the built-in rechargeable
batteries. It can be operated on either the AC adapter or the rechargeable batteries.
Read all instructions carefully before use.
CLIPPER CHARGING PRECAUTIONS
• Do not use any power cord or AC adapter other than those provided.
• Avoid charging the batteries at temperatures below 5°C or above 35°C.
• Avoid charging the batteries in direct sunlight or near a radiating heat source.
• Even though the clipper may not be used for an extended period, charge once a
month to preserve battery life.
• The power cord cannot be replaced. If it is damaged, the AC adapter should be dis-
carded.
CLIPPER OPERATING PRECAUTIONS
• This clipper has a built-in rechargeable battery. Do not throw into fire, apply heat, or
charge, use, or leave in a high temperature environment.
WARNING
Keep the appliance dry.
• The clipper may become warm during operation and/or charging. This is normal.
• Check that the blades and the attachments are not damaged before use. Replace
them if they are damaged.
• Before each use, apply oil at the places marked with arrows (see drawing).
• Do not allow permanent wave lotion, hair restorer or hair spray to come into contact
with the main body or the blades. Doing so may result in cracking, discoloring or
corrosion.
• Do not drop the clipper on the floor.
• Do not knock the blades and the attachments against hard objects.
• Do not use the clipper to trim the hair of a pet.
CLIPPER CLEANING PRECAUTIONS
• Clean the housing using only a cloth slightly dampened with water or a mild soap
solution.
• Never use a caustic solution.
• Never submerge the clipper in water.
CHARGING THE CLIPPER
1. Slide the power switch to OFF position.
2. Connect the plug from the AC adapter to the unit. The LED will turn red to indicate
charging.
3. Place the unit on the stand or on a counter.
• It will take approximately 3 hours for the clipper to fully charge, as indicated by the
blue LED light. This will give you approximately 3 hours or more of run time.
• Your clipper can be quick charged for approximately 1 hour, providing about 75
minutes of run time. Note the LED light may not change from red to blue.
• Important Note: To prolong the life of your battery, it is recommend that you wait
for the flashing red LED before charging your clipper.
ABOUT THE LED DISPLAY
Your clipper has one LED to indicate the different modes.
9