BaByliss PRO X2 VOLARE maxlife PRO FX811E Mode D'emploi page 13

About the Lithium-Polymer Battery Pack
To ensure that the new battery reaches its full potential, the battery should be drai-
ned to rapid flashing red LED after the first use. This operation will only have to be
performed once. The unit should then be fully charged until blue LED appears.
Note: It may take 5-10 charging cycles for the battery to reach its full potential.
Removing the Built-in Rechargeable Battery Pack
1. Turn unit off and disconnect the clipper from household outlet.
2. Discharge the battery pack completely before removing it.
1 2
3. Remove the blades and four screws .
3
4. Lift off outer housing .
4
5. Remove the lithium-polymer battery .
2
3
4
1
13