Rear Panel; Power Switch - Fender '65 PRINCETON REVERB Mode D'emploi

J. POWER CORD SOCKET: Connect to a grounded A/C
outlet using the supplied power cord, in accordance with
the voltage and frequency ratings specified on the rear
panel of your amplifier.
K. FUSE: Protects the amplifier from electrical faults.
Replace a blown fuse only with the type and rating
specified on the rear panel of your amplifier.
L. POWER SWITCH: Turns the amplifier on-off as indicated
by the front panel power jewel.
M. INTERNAL SPEAKER: Plug-in connection for the 8Ω
internal speaker. A speaker must always be connected at
this jack when the amplifier is ON. A speaker impedance
load of 8Ω should be used to avoid distortion or damage
to the amplifier. When using only the internal speaker
jack, a speaker impedance load of 8Ω (minimum) should
be used to avoid distortion or damage to the amplifier.
Your new Fender amplifier comes equipped with the
highest quality tubes available, sourced from various
manufacturers all over the world. Because of occasional
irregularities in supply, the specific tube type used in each
amplifier is subject to change without notice.
When replacing output tubes, please note the specific
tube markings on the original tubes factory supplied with
your amplifier. For example, 6L6 output tube types used
by Fender include, but are not limited to: 6L6GC; 6L6WXT;
6L6C; 6L6GE; etc. The installation of a different type may
require significant adjustment by a qualified technician to
avoid reduction in performance and tube life.
Additionally, Groove Tubes™ sorts and tests many of our
output tubes, and paints them with a color-coded label. If
your amp came supplied with, for example, white-labeled
TYPE
POWER REQUIREMENT
INPUT IMPEDANCE
POWER AMP OUTPUT
SPEAKERS
DIMENSIONS
WEIGHT

REAR PANEL

VACUUM TUBES
SPECIFICATIONS
PR 770
125W
1MΩ
12W into 8Ω @ < 5% THD, 1kHz
One 8Ω, 10", Jensen Special Design C-10R, (PN 0069347000)
Height: 16 in (40.6 cm)
34 lb (15.42 kg)
Product specifications subject to change without notice.
N. EXTERNAL SPEAKER: Plug-in connection for an external
speaker. This jack is wired in parallel with the INTERNAL
SPEAKER JACK (M) and affects the speaker impedance
load. Use 8Ω minimum total. To use the external speaker
output, first disconnect the internal speaker. Then
connect a 16Ω speaker load (minimum) to the internal
speaker jack and another 16Ω speaker load (minimum)
the external speaker jack.
O. FOOTSWITCH: Plug the (included) 2-button footswitch
in here. The footswitch enables remote switching of the
reverb and vibrato effects.
P. REVERB JACKS: RCA jacks route signal to and from
reverb tank.
6L6WXT tubes, then a new set of white 6L6WXT tubes will
be the perfect direct replacement.
If you have questions or concerns, contact your Fender
dealer or authorized service center.
'65 Princeton Reverb Amp
Tube locations left to right at rear:
5 6
A V
R 6
4 GT
Width: 19 7/8 in (50.5 cm)
6
6
V
6
GT
12 12 12 12
AX AX AT AX
7A 7A 7 7A
Depth: 9 1/2 in (24.1 cm)