Rear Panel - Fender Acoustic 100 Manuel D'utilisation

Rear Panel

ON OFF
1
3
INPUT POWER
4
FOOTSWITCH
2
1
POWER: Turns Acoustic 100/200 on and off.
2
IEC POWER INLET: IEC power cord connects to Acoustic
100/200 here.
3
USB PORT: For audio recording to a computer. When
connected, computer's audio control panel will display
"Fender Acoustic" as an audio recording device.
4
FOOTSWITCH: Input jack (¼") for connecting compatible MS4
and MGT-4 four-button footswitches (optional).
5
BALANCED LINE OUTPUTS: Balanced mic-level XLR output
jacks for connection to external sound reinforcement and
recording devices.
5
RIGHT LEFT
BALANCED BALANCED
LINE OUT LINE OUT 1
2
3
4
5
6
Footswitch
Use included magnetic label to convert optional MS4 and MGT-4 four-button footswitches
for use with Acoustic 100/200.
1
2
MANUAL/PRESET MODE: Manual mode delivers amp control panel settings, indicated by
red LED above. Press button to cycle through manual mode and three effects presets; LEDs
at left indicate which preset is active. To create effects presets, press and hold button to
save FX SELECT (8), FX LEVEL (7) and tempo settings for both channels; DISPLAY WINDOW
(item 4 below) will confirm preset by briefly flashing "P1", "P2" or "P3". If FX SELECT, FX LEVEL
or tempo settings are changed while on an active preset, preset LED will blink to indicate
settings have changed and must be saved.
FX1: Press for channel one effects on/off (red LED indicates on). Press and hold for channel
one tuner (mutes channel one only). Note appears in display window; four red LEDs at top
indicate sharp/flat pitch, and CENTER TUNER LED (item 3 below) illuminates green at correct
pitch. Press button again to return to play mode.
CENTER TUNER LED: In tuning mode, illuminates green when correct pitch is attained (four
red LEDs at top indicate sharp/flat pitch).
DISPLAY WINDOW: Shows tuning mode and effects preset information.
FX2: Channel two effects/tuner operation identical to FX1 (item 2 above).
TAP TEMPO: Controls time-based effect tempos (echo, delay, delay plus chorus, delay plus
reverb) for both channels. Tap to set delay time for active effect(s) only; red LED above will
flash in time accordingly. If delay effects are selected on both channels, TAP TEMPO will set
both effects. If FX SELECT (8) is changed, delay time for that effect will revert to default value.
TAP TEMPO is global for all modes and presets, enabling switching among effects while
keeping same tempo.
4
3
5 6
4