Main Screen Description - Promax TVHUNTER Manuel

3.3 Main Screen Description.

The top line of this screen is the same one for all functions of the equipment. Next
it will be explained the icons and messages that can appear depending on the situation.
At the top left corner it is shown the active function. There are three different
states or functions: 1) DETECT, 2) IDENTIFY and 3) ADJUST.
When using the TVHUNTER, it may appear on the display some messages and
icons, depending on the status or event is taking place. These messages and icons are
detailed below:
Message
"LOW BATTERY"
"VERY LOW BATTERY"
"SUPPLY SHORT CIRCUIT"
"SUPPLY OVER CURRENT"
"MANUAL POWER OFF"
"AUTO POWER OFF"
"SERVICE MODE"
"BATTERY MODE"
"UPDATE MODE"
"NETWORK NOT FOUND"
"SERVICES NOT FOUND"
"SIGNAL NOT DETECTED"
"FULL BATTERY"
"MPEG-2 NOT DETECTED"
"LOADING NETWORK"
"LOADING SERVICES"
"HIGH TEMPERATURE"
Page 10
Figure 4.- Main Screen (on Detect Screen).
Low power level battery. Plug it to the charger.
The equipment will be switched off immediately.
The external supply can be shortcut.
The external supply has a high current consumption.
The instrument has to be switched off by hand.
The instrument will switch off after five minutes of inactivity.
Normal operation mode.
When the battery is being charged.
When the instrument is being updated.
The instrument cannot find a TV network.
The instrument cannot detect the services of a network.
When no signal is detected.
Battery fully charged.
It is not detecting the Transport Stream MPEG-2 signal.
After finding a signal, needs a time to load the network.
After finding a network, needs a time to load services.
The running temperature is too high. The instrument must
be switched off for a while. If the problem persists, contact
with the technical support.
USER'S MANUAL. TVHUNTER.
Description
10/2010