Introduction; Safety Instructions - Ayrton Rollapix 100 Manuel D'utilisation

Introduction

Thank you for your patronage. We are confident that our
excellent products and service can satisfy you. For your own
safety, please read this user manual carefully before installing
the device.
In order to install, operate, and maintain the lighting safety and
correctly. We suggest that the installation and operation should
be done by the verified technician and follow the instruction
strictly.
CAUTION !
Unplug mains lead before opening the housing.
Every person involved with the installation, operation and
maintenance of this device has to:
be qualified
follow carefully the instructions of this manual
Thank you for having chosen this professional LED Moving Head
projector.
You will see you have acquired a powerful and versatile device.
Unpack the device. Inside the box you should find :
1. One power connection cable
2. Two omega clamps
3. One safety rope
4. Manual
Please check carefully that there is no damage caused by
transportation. Should there be any, consult your dealer and
don't install this device.

Safety instructions

Avant toute installation et utilisation du projecteur ROLLAPIX
100, veuillez lire attentivement les instructions de sécurité et les
précautions d'utilisation mentionnées ci-dessous.
CAUTION !
Be careful with your operations. With a dangerous
voltage you can suffer a dangerous electric shock
when touching wires.
This device has left the factory in perfect condition. In order
to maintain this condition and to ensure a safe operation, it is
absolutely necessary for the user to follow the safety instructions
and warning notes written in this user manual.
Important :
Damages caused by the disregard of this user manual are not
subject to warranty. The dealer will not accept liability for any
resulting defects or problems.
If the device has been exposed to temperature changes due
to environmental changes, do not switch it on immediately.
The arising condensation could damage the device. Leave the
device switched off until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential
that the device should be earthed.
The electric connection must carry out by qualified person.
No move at operating mode.
If the external flexible cable or cord of this luminaire is damaged,
it shall be exclusively replaced by the manufacturer or his service
agent or a similar qualified person in order to avoid a hazard.
Make sure that the available voltage is not higher than stated at
the end of this manual.
Make sure the power cord is never crimped or damaged by
sharp edges. If this would be the case, replacement of the cable
must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use
or before cleaning it. Only handle the power cord by the plug.
Never pull out the plug by tugging the power cord.
Fixtures cannot be installed on combustible substances, keep
more than 50cm distance with wall for smooth air flow, so there
should be no shelter for fans and ventilation for heat radiation.
CAUTION !
PROJECTOR USING CLASS 2 LED SOURCES
This device uses multiple high-power
(CLASS 2) LED
(Light Emitting Diode) light sources.
Never look directly at the light source when it is lit; never stand
directly in the device's beam close up.
Always ensure the power is disconnected when installing,
dismantling or replacing the device to prevent any risk of glare
and to avoid any harm to your eyes.
CAUTION !
Never touch the device during operation !
The housing may heat up.
CAUTION !
Never look directly into the light source, as sensitive
persons may suffer an epileptic shock.
Please be aware that damages caused by manual modifications
to the device are not subject to warranty. Keep away from
children and non-professionals.
USER MANUAL
4
(EN60625-1 : 1994)