Setting Up
1
Unfold the antenna module slowly.
Be careful not to hit anyone or anything when unfolding the
antenna module.
2
Pull out the long cord with the double pin plug from
the antenna controller until it stops, and connect it to
the antenna module.
3
Attach the antenna module to the window glass or the
curtain.
Fix the antenna with the supplied clip or the suction cup, as seen in
the illustration on the previous page.
4
Connect the short cord with a single pin plug to the
AM EXT ANT (AM external antenna) jack of the radio.
The power supply of the antenna controller is linked to the power
supply of the radio. The POWER lamp lights up on the controller.
Switch ATT to OFF on the radio.
On setup
• Place the antenna module where reception is well, such as by the
window.
• Reception may become poorer if the long cord of the antenna
controller is kept near the radio. Keep it as far away from the radio as
possible.
• Keep the radio and the antenna away from fluorescent lamps,
television sets, telephones, personal computers, etc., as they may
generate noise interference.
• Set up the antenna as far away from the street as possible.
• Do not use the antenna outdoors.
• When using the external antenna, be sure to retract the telescopic
antenna on the main unit.
To AM EXT ANT
Other operations
GB
33